MSI GT70 (MS-1762)

Disassembly Process

MSI GT70 Series Notebook consists of various modules. This chapter describes the procedure for the complete notebook disassembly. In addition, in between procedures, the detailed disassembly procedure of individual modules will be provided for your needs.

The disassembly procedure consists of the following steps:

  • Battery Module 
  • Memory Module 
  • HDD Module 
  • Wireless LAN (Wi-Fi) Module 
  • Keyboard Module 
  • FAN Module 
  • LCD Module 

Battery Module

 The illustration below shows how to remove the Battery Module.

Remove Battery Module

1. Open the battery latch1, and hold the battery latch2 to take the battery away.


HDD Module

The illustrations below show how to remove the HDD Module from the notebook.

Remove HDD Module

1. Remove the 12 screws (M2.5*7mm). Then remove the Bottom door. Remove the 4 screws (M2.5*5mm) and remove the two HDD Module according to the direction as pic shows.


FAN Module

The illustrations below show how to separate the FAN module.

Separate FAN module

1. Remove 7 screws (M2.5*5mm) on the thermal module assy & remove the 1 screw (M2.5*5mm) and FAN cable, after that remove the Fan.


Memory Module and VGA Module

The illustration below shows how to remove the Memory Module and VGA Module from the notebook.

Remove the Memory Module and VGA Module

1.1. Pry the 2 latches on the memory to pop up the memory. Then remove the memory.

1.2. Remove 1 screw (M2.5*5mm), then remove the VGA card as pic shows.


Wireless LAN (Wi-Fi) Module

The illustration below shows how to remove the Wireless LAN Module from the notebook.

Remove Wireless LAN Module

1. Remove the Middle Cover. Care the Sensor board FPC below the cover. Remove the left and right hinge caps. Remove MIC cable and remove the 1 screws on Wireless LAN card and pull out the card from its slot.


Keyboard Module

The illustration shows how to remove the Keyboard Module form the notebook.

Remove Keyboard Module

1. Remove the 5 screws (M2*4mm) that stabilize the keyboard. Then remove the Keyboard. Push connector according to the direction as pic shows, then remove the cable.


LCD Module

The illustrations below show how to remove and disassemble the LCD Module.

Remove the LCD Module

1. Remove the 2 screws (M2.5*7mm) that stabilize the left LCD hinge and right LCD hinge.

2. Remove the 2 screws (M2.5*5mm), then remove the LCD bezel, should begin from the two sides, then the upside to downside. Remove the 3 screws (M2.5*5mm) that stabilize the left hinge and right hinge.

4. Remove the 6 screws (M2.5*5mm) and remove the camera cable, and then remove the display module from LCD cover. Remove the LVDS cable from display module.